Film Dilimleme veya Yeniden Sarma Sırasında Neden Sürekli Kopar?

Why Does Film Keep Breaking During Slitting or Rewinding? Film may run normally and then break during acceleration. It may repeatedly tear from the same edge, fail in one narrow slit strip, or break near the same roller position. Changing the overall tension is rarely the best first step. A better starting point is to

Film Dilimleme veya Yeniden Sarma Sırasında Neden Sürekli Kopar? Devamını Oku »

Film Dilimleme Kenar Kusurları: Kıvrılma, Pürüzlü Kenarlar, Toz ve Genişlik Değişimi

Film Slitting Edge Defects: Curl, Rough Edges, Dust, and Width Variation When slit film shows curled edges, rough cuts, dust, or unstable width, inspect the edge immediately after cutting. This first observation helps separate a cutting problem from an issue that develops farther downstream. If the defect is already visible at the knife, start with

Film Dilimleme Kenar Kusurları: Kıvrılma, Pürüzlü Kenarlar, Toz ve Genişlik Değişimi Devamını Oku »

Film Bobini Sertlik Sorunları: Bloklaşma, Yıldızlanma ve Sert veya Yumuşak Bölgeler

Film Roll Hardness Problems: Blocking, Starring, and Hard or Soft Spots If a film roll is very hard near the core, loose on the outside, blocked after storage, or marked by hard and soft lanes, first find out where the problem starts. A roll that becomes too tight in the first few wraps needs different

Film Bobini Sertlik Sorunları: Bloklaşma, Yıldızlanma ve Sert veya Yumuşak Bölgeler Devamını Oku »

Sarılmış Bobin Şekil Kusurları: Teleskoplanma, Çanaklaşma, Gevşek Kenarlar ve Çekirdek Sorunları

Wound Roll Shape Defects: Telescoping, Dishing, Loose Edges, and Core Problems A finished roll may have stepped layers, a curved face, loose edges, or a core that has moved inside the roll. Some problems show up while the roll is still winding. Others appear after unloading, transport, or storage. Before changing settings, look at the

Sarılmış Bobin Şekil Kusurları: Teleskoplanma, Çanaklaşma, Gevşek Kenarlar ve Çekirdek Sorunları Devamını Oku »

Kauçuk Merdane Dinamik Balans: Ne Zaman Önemlidir?

Rubber Roller Dynamic Balancing: When It Matters A rubber roller may run smoothly at low speed, then start to show vibration, noise, bearing heat, or light repeat marks after the line speeds up. This often happens on high-speed rollers, long face rollers, heavy rubber-covered rollers, wide web lines, slitting and rewinding machines, film converting lines,

Kauçuk Merdane Dinamik Balans: Ne Zaman Önemlidir? Devamını Oku »